My m50 is pinging. Running out of ideas.

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • Dj Buttchug
    replied
    mines detonating again... FML

    I cannot for the life of me distinguish the noise between pinging or vanos noise. Its extremely faint but its there especially under load at freeway speed like previously stated.

    I have done

    new plugs NGK
    new O2
    all New coil packs BAV auto
    fuel pump is new TRE 304
    always 91 fuel
    Last edited by Dj Buttchug; 06-27-2014, 10:18 PM.

    Leave a comment:


  • Wishno87
    replied
    Not exactly sure. It goes on the ground that attaches by the vanos. I was told that someone had similar issues and fixed it by replacing that resister so I'm just following any leads I can get now.

    Leave a comment:


  • Ryann
    replied
    Negative. I will this weekend. So, the idea is that the resistor gets hot and drops injector voltage which reduces duration? Er what?

    Leave a comment:


  • Wishno87
    replied
    Swapped ECUs today. Almost seems to be worse now. Still need to buy that resister. Ryan have you checked yours out yet? It's right under your fuel rail cover.

    Leave a comment:


  • Ryann
    replied
    Any updates?

    Leave a comment:


  • e30austin
    replied
    However, I'd say Josh's is in good shape compared to 99% of the ones I've seen.

    Leave a comment:


  • e30austin
    replied
    All the TU cars had them. It's a 240 ohm resistor that is the main ground wire for the DME (goes directly to pin 15 iirc). They're known to crack and do funny things.

    Leave a comment:


  • Ryann
    replied
    A resistor in an injector ground wire? Weird.

    Leave a comment:


  • Wishno87
    replied
    Someone told me they had similar issues with a damaged resister so I will replace it and let you guys know what happens.

    Leave a comment:


  • Wishno87
    replied
    Anyone know anything about this? It seems to be some sort of fusible link or resister. Its on my injector harness and its cracked.

    Leave a comment:


  • Wishno87
    replied
    Stock ecu and I always use. 91.

    Leave a comment:


  • 88SuperETABD
    replied
    I didn't read all the pages, but have you considered your tune/ecu to be the issue? also what gas you using? does it ping if you use higher octane?

    Leave a comment:


  • Dj Buttchug
    replied
    damn. wtf can this be. fuel press is solid for sure

    Leave a comment:


  • Wishno87
    replied
    So this is where my fuel pressure is at and it did not move as I revved it up.

    Leave a comment:


  • Wishno87
    replied
    I used the spray stuff. It comes with a tube you put in your throttle body. I will try it that way next time though. Cool site! Thanks for the link.

    Leave a comment:

Working...