Hi Gang,
This weekend I was running the car as part of a race weekend for the first time in 2 years. The car ran awesome but felt down on power in the 3-5k range. I didn't pull the codes until after the race but there are a bunch.
3D DME Pedal Position Sensor 2 Signal
2C DME Thermal Oil level Sensor (NOT USED)
78 DME Electric Throttle potentiometer signal comparison
6B DME Electric Throttle Self Test
24 DME Tank Venting Valve (NOT USED)
36 DME System Volatge Main Relay
7 DME Camshaft Sensor Inlet
A DME Exhaust Camshaft Sensor Signal
B9 DME Function Exhaust Vanos
B8 DME Function Intake Vanos
19 Cylinder 1 Ignition Coil
17 Cylinder 2 Ignition Coil
34 Cylinder 5 Ignition Coil
33 Cylinder 6 Ignition Coil
32 Cylinder 4 Ignition Coil
18 Cylinder 3 Ignition Coil
There was no misfiring or anything like that, just that in retrospect I don't think the vanos was functioning and with all those codes there seems to be a supply or reference voltage (or ground issue). I clear the codes and they all come back immediately on start up.
There is no power at pin 8 of x60001. Can someone confirm what feeds pin 8? I thought it might be the DME relay but it checks out. It originates in the main harness junction box that sits under the manifold but the TIS has been no help.
Thank you in advance!
Anthony
This weekend I was running the car as part of a race weekend for the first time in 2 years. The car ran awesome but felt down on power in the 3-5k range. I didn't pull the codes until after the race but there are a bunch.
3D DME Pedal Position Sensor 2 Signal
2C DME Thermal Oil level Sensor (NOT USED)
78 DME Electric Throttle potentiometer signal comparison
6B DME Electric Throttle Self Test
24 DME Tank Venting Valve (NOT USED)
36 DME System Volatge Main Relay
7 DME Camshaft Sensor Inlet
A DME Exhaust Camshaft Sensor Signal
B9 DME Function Exhaust Vanos
B8 DME Function Intake Vanos
19 Cylinder 1 Ignition Coil
17 Cylinder 2 Ignition Coil
34 Cylinder 5 Ignition Coil
33 Cylinder 6 Ignition Coil
32 Cylinder 4 Ignition Coil
18 Cylinder 3 Ignition Coil
There was no misfiring or anything like that, just that in retrospect I don't think the vanos was functioning and with all those codes there seems to be a supply or reference voltage (or ground issue). I clear the codes and they all come back immediately on start up.
There is no power at pin 8 of x60001. Can someone confirm what feeds pin 8? I thought it might be the DME relay but it checks out. It originates in the main harness junction box that sits under the manifold but the TIS has been no help.
Thank you in advance!
Anthony
Comment