Announcement

Collapse
No announcement yet.

Transfer case front output seal question

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Transfer case front output seal question

    Does anyone know if the front output shaft seal – in the transfer case, that goes to the driveshaft in the front axles, can be replaced with the transfer case in the car? Or does it need the case need to be removed?

    #2
    Did it on mine in car ,and there's two seals (first is in backwards with tension spring removed,its a dust seal )just monitor depth carefully before removing old ones and wrap shaft with tape so as not to damage new seals upon install

    Sent from my SM-G360V using Tapatalk
    Last edited by spdracrm3; 11-18-2015, 02:09 PM.
    Angus
    88 E30M3 X2
    89 325IX
    92 R100GS/PD
    :)

    Comment


      #3
      Ive posted the pages from the factory manual showing proper install/removal on this site before ,a search might find them.

      and here you go http://www.r3vlimited.com/board/show...ght=Tcase+seal

      Sent from my SM-G360V using Tapatalk
      Last edited by spdracrm3; 11-18-2015, 02:12 PM.
      Angus
      88 E30M3 X2
      89 325IX
      92 R100GS/PD
      :)

      Comment


        #4
        Thanks for the quick response guys. Glad I can do it in the car, any special tricks or special tool that I should know about?

        Comment


          #5
          It might be a little tricky just because you do not have as much space with tools under there. Be careful not to gouge the case housing pulling the old seals.

          As far as tools go, a strong hook without a sharp tip works.

          Comment


            #6
            Thanks, appreciate your feedback!

            Comment

            Working...
            X