So not sure what is going on here, I assumed the high beams were H1. They fit in the housing, but how do I connect them to the wiring?
-
If you put the bulb in, the red spade connector attaches to the bulb and the round terminal goes over the ground post to the left. Then on the other side of the cap, you can slide their wiring over the terminals or use the correct BMW style connector."I'd probably take the E30 M3 in this case just because I love that little car, and how tanky that inline 6 is." - thecj
85 323i M TECH 1 S52 - ALPINEWEISS
88 M3 - LACHSSILBER
89 M3 - ALPINEWEISS II
91 M TECH CABRIO 2.7L TURBO - MACAOBLAU -
Comment
Comment