what supposed to be holding my battery?

[guibo09]

does the battery need to be vented to the outside? there is the large flappy vent right near by the battery, is this enough? or should i pipe a tube from the battery vent hole to the rubber grummet at the base of the battery tray?

does the tube exit have to be higher than the battery?

[Liam]

You should have a tube that drops out the bottom of the car that goes to the vent (it's there in case the battery pukes).

[guibo09]

You should have a tube that drops out the bottom of the car that goes to the vent (it's there in case the battery pukes).

the PO didnt vent his battery... so no signs of a vent tube.

where exactly does the tube exit? does it exit right under the battery plastic tray? there is a hole with a rubber grommet i can easily pass a tube through. or does it go somewhere else?

[Liam]

the PO didnt vent his battery... so no signs of a vent tube.

where exactly does the tube exit? does it exit right under the battery plastic tray? there is a hole with a rubber grommet i can easily pass a tube through. or does it go somewhere else?

Yes it exits at the bottom of the car. Small plastic tube through a grommet in front of the right rear wheel)

[guibo09]

Yes it exits at the bottom of the car. Small plastic tube through a grommet in front of the right rear wheel)

thanks! i found the tube, and the little expansion container for the vent that goes to the bottom of the tray on realoem. cheap parts too.

[Liam]

thanks! i found the tube, and the little expansion container for the vent that goes to the bottom of the tray on realoem. cheap parts too.

You're welcome, glad I could help.

[M3Driver]

I have the factory plastic tray and use a small ratchet strap to cinch it down.

To keep the strap in place, I slotted the battery tray on each side of the battery with my cutting wheel, and then passed the strap through under the tray and back up again on the other side. The ratchet itself sits between the battery posts and is easy to access.

It works really well: very snug, cheap, easy to remove/install, passes tech, and you probably have one in your garage waiting for a decent use :)

[Merlin8]

the cables hold it down good enough ;)

the weight of the battery will weaken the cables during breaking and acceleration and eventually they will break. ive had mine strapped down with a truck bed strap since the stock pin rusted out for 6 months but still the cables bent and began to break. scary electrical issues on the freeway today. not good.

[Mr. Tasty]

the weight of the battery will weaken the cables during breaking and acceleration and eventually they will break. ive had mine strapped down with a truck bed strap since the stock pin rusted out for 6 months but still the cables bent and began to break. scary electrical issues on the freeway today. not good.

awesome. You just bumped a 4 year old thread.

Kudos

[diamonddonbmw]

Thank you also!! I've been looking for this info too��