Update:
Working on a third microcontroller to try and run it. A Keystudio Arduino Uno copy with the SMD controller with the two extra analog inputs needed for three displays, as the screen itself requires four on its own for the touch functionality. If this works, this will make the gauge much simpler internally and remove the need for any solder on the inside. The board will be modified to accept signals from the backside as well.
Also working on running a housing from ASA, but having warpage issues. Gonna figure out an enclosure soon after some more PLA prototypes are sorted out.
Making progress, not quite there yet but close.
Working on a third microcontroller to try and run it. A Keystudio Arduino Uno copy with the SMD controller with the two extra analog inputs needed for three displays, as the screen itself requires four on its own for the touch functionality. If this works, this will make the gauge much simpler internally and remove the need for any solder on the inside. The board will be modified to accept signals from the backside as well.
Also working on running a housing from ASA, but having warpage issues. Gonna figure out an enclosure soon after some more PLA prototypes are sorted out.
Making progress, not quite there yet but close.
Comment