HID: Load Resistor

[Maddog]

I finally bit the bullet and installed a Morimoto HID setup using its own relay harness. As part of it, I installed in parallel a 50 watt 6 ohm load resistor to avoid a low beam check light; HID lamps are 35 watts.

The load resistor seems to overheat after the lights running for 15-30 minutes and the circuit triggering the low beam out light, but after works again after cooling off. The resistor is mounted on a metal surface.

Has anyone experienced this? I plan to replace the load resistor and if it still persists to upgrade the resistor to a 100 watt 6 ohm.

Appreciate your feedback/insight.

[MrBurgundy]

I use these and never get any kind of indication unless a light is actually out

https://www.morimotohid.com/morimoto-canbus-2-hid-harness?quantity=1&utm_medium=cpc&utm_source=googl e&utm_campaign=22430343077&utm_content=_c_&gclsr c= aw.ds&gad_source=1&gad_campaignid=22430344715&gbra id=0AAAAAoSgE2_2tmaOrKQ5DFZCoKWBmOq9K&gclid=CjwKCA jw-rTUBhAiEiwADv8gBJnawndZgcLsogMjcjq7w2_9CddIDIbj9IL t8qQDp9zzsKb0DZmwgxoC1AcQAvD_BwE

[Maddog]

Thanks MrBurgundy. Will give it a try.

[MrBurgundy]

Thanks MrBurgundy. Will give it a try.

np my guy