If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
Taurus side skirts - modification and installation
It probably would if it weren't for that switch/latch at the front. Doesn't match anything else in the car.
Actually, I thought about painting that the same color as the pleather but that switch performs a very cool function in that it allows access to either a top tray or a deeper bottom storage area depending on where it's set to before being opened.
Are these skirts straight across the top edge or is my set bowed a little?
Mine were very slightly bowed, but if you mount them on the sides, not just underneath, it should straighten out and fit correctly. These are meant for other cars, remember, so it's not 100% fitment, though very close.
you know i gotta admit i like the cup holder idea, if i could manage to make it flush up more to look OE i might do this...though i would shift it forward more and put another one behind it for dual cup holders :D
Kyle Sutherland
1995 BMW 540i/6: The Calypso Beast Vid 0-70ish 1987 BMW 325es: Face & Butt Lifted/M50tu Swapped*Sold* 1985 VW Scirocco: Too many mods, money pit*Sold*
I actually just picked up a husco tractop for $35, so my Probe one's out. That console looks like it fits a lot better than mine did, because mine was rounded. The tractop looks sooooo much better ;)
sho skirts are very different than regulars, they end up being wider but cut towards the inside sharply at 90 degrees to match the claddings on the doors.
Here's my set... Excuse the bodywork and paint, all done by me and these things were in TERRIBLE condition. Didn't help that our PnP puts wheels right under the skirts of these things. These were the only 2 I could pull off from different cars, and probably the worst condition in the yard. I am happy with the result though for ~$75 including buying the spray gun, mask, and compressor fittings. I think they'll look really good with the addition of a rear apron.
"A good memory for quotes combined with a poor memory for attribution can lead to a false sense of originality."
-----------------------------------------
91 318is Turbo Sold
87 325 Daily driver Sold
06 4.8is X5
06 Mtec X3
05 4.4i X5 Sold
92 325ic Sold & Re-purchased
90 325i Sold
97 328is Sold
01 323ci Sold
92 325i Sold
83 528e Totaled
98 328i Sold
93 325i Sold
Comment