Someone left the oven on. Intermediate bearings. 11-11-1-264-196 11-11-1-280-863

[ForcedFirebird]

Cast/billet 932 silicone bronze m20 intermediate shaft bearings. Part numbers 11-11-1-264-196 and 11-11-1-280-863, but better. No one in the world seems to have the inner, so I just made them from scratch for engines we are building in-house. Already turned to ID for direct press and ream. Feel like making jewelry. lol. These need one more operation (oil hole), and ready to install.

[ForcedFirebird]

:)

[whodwho]

Very nice! Making extras that we can buy?

Looks like you could make up some nice cam bearings and save some old worn out heads, just need to make a boring bar setup 8^)

[ForcedFirebird]

Very nice! Making extras that we can buy?

You're the fourth to ask, so sure: https://www.r3vlimited.com/board/for...rings-upgraded

Looks like you could make up some nice cam bearings and save some old worn out heads, just need to make a boring bar setup 8^)

Quite a long bar, too! IIRC the m20 cam bearings are already available. I might worried about thinning the cam valley (where they always crack), though.