19# injectors, would these work?

[Sagaris]

http://cgi.ebay.com/ebaymotors/19LB-...item3359e2e543


or in other words
Is a 19# fuel injector a 19# fuel injector? or do I need to watch out for different nozzles, plug connectors and brands?

[2.5-12]

those work.

[Sagaris]

I called Mark D and he convinced me to go with 17# injectors. He said that part of the reason he made the chip for the 19# is because that is the size the Mustang uses which should make them more available /cheaper. Looks like im going to be looking for some 17#ers thanks for the confirmation though

[2.5-12]

alrighty, the ECM re calibrates just perfect with the ford 19# injectors though ;)

[AlarmedBread]

alrighty, the ECM re calibrates just perfect with the ford 19# injectors though ;)

WRONG, post a dyno sheet with AFR please. ;) Stock ecu will run about 10.5 AFR with 19lb injectors.

[LowR3V'in]

but but but but the ecu will make it perfect. j/k

[MR 325]

17, a much better choice.

[2.5-12]

fair enough - I guess I just assumed it was calibrated since I run the 19lb injectors and they seem fine,

still learning about the M20 every day

[Tree_e30]

dont waste your money unless you get a fuel pressure reg the maf doesnt adjust to the large amont of fuel the bads are 1 the engine light stays on 2 car runs to rich and 3 the car losses power low end i hear alot of buzz about these but honestly my car felt better with 13lb

[kamotors]

dont waste your money unless you get a fuel pressure reg the maf doesnt adjust to the large amont of fuel the bads are 1 the engine light stays on 2 car runs to rich and 3 the car losses power low end i hear alot of buzz about these but honestly my car felt better with 13lb

,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
....................................

[TrentW]

Part # for the 17lb injectors?

[Sagaris]

RealOEM has 13641730060 for a part# on M50 injectors off a '95 E34. I would look at my own injectors which are on the car, but a giant aluminum crab is guarding them :(

[nando]

you don't have to remove anything but the injector harness and fuel rail to get at the injectors. taking the valve cover out of the way helps though.

[rvaughnp]

Do these have the 4 pintle design? The realoem ones. I found them but just curious.

[Adrian_Visser]

No they would be single pintle design II and that is the BMW part number. It is virtually meaningless to anybody but the dealership's part system or a vendor that uses the BMW system. The bosch number for a design III (newer with a better spray pattern and four pintle tip)

Like these:

http://cgi.ebay.com/ebaymotors/ws/eB...70074305043776

Witchhunter.com has info on most fuel injectors available:

http://www.witchhunter.com/injectordata1.php4

An M50 runs at 3.5 BAR fuel pressure where as an M20 only runs 3.0 BAR so an injector that flows 17.5 lb/hr at 3.5 BAR will only flow 16.2 lb/hr at 3.0 BAR keep that in mind.