Announcement

Collapse
No announcement yet.

HG/timing belt/arp head studs installed no start

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    HG/timing belt/arp head studs installed no start

    Recently blew the HG, so I decided to Redo everything. Put new plugs, 19lb injectors and the mark d chip for the 19lb. So first start up a bit of sputtering and it ran and idled around 1300rpm. Third startup it just cranked no start. Checked for spark and I have spark. Checked my dipstick and it smells like fuel. So I'm getting fuel lol. Went a pulled a plug and it was drenched in fuel. Guessing that was my fault pressing the gas pedal trying to start it up that third time. Any ideas?
    sigpic

    #2
    Try again after it isn't flooded? Btw, holding the pedal all the way to the floor on Motronic should put it in a "flood clear" mode.

    Comment


      #3
      Check your timing belt again, and try putting the stock chip or ECU back in.
      -Alex

      Comment


        #4
        Im going to put the stock chip and injectors in
        sigpic

        Comment


          #5
          Plugs fouled???

          FPR bad??

          Comment


            #6
            Ok didn't change anything to stock but it starts and idle at 2grand. Checked for vacuum leaks. Gonna recheck everything.
            sigpic

            Comment


              #7
              Always check the TB stop screw. I know it has made me feel like an idiot on at least one occasion.

              Comment


                #8
                Make sure if you have cruise control and the cruise control cable or your throttle cable is not caught/hung up on something
                1997 Artic Silver M3
                CES GT4094r 651hp/615tq @ 24 psi

                Comment


                  #9
                  sounds like those injectors/ chip isnt right. and its dumping fuel in like theres no tomorrow. id let it clear, refit the stock injectors and chip or get it tuned properly.

                  Comment


                    #10
                    Turn down the idle screw and I just bought a m30 maf today to see if that flappy door maf I have is restricting air. It idles great and starts so I'm getting closer to actually driving my car but I smell the richness in fuel
                    sigpic

                    Comment


                      #11
                      Put the stock stuff back in and it runs like how it use to. Thanks for the input
                      sigpic

                      Comment


                        #12
                        Back to stock and runnin
                        sigpic

                        Comment

                        Working...
                        X