m20 setup?

[BavBeater85]

Anybody have any thoughts on this setup? was thinking about running a Myster E head with 280 cams, extrude honed intake manifold, 64.5mm throttlebody, miller maf with war chip and keeping my 19# injectors...worth my money for the gains or not

[nny403]

Sure for like 10hp. Boost it.

[Cronopoulos]

Sure for like 10hp. Boost it.

I would assume he is doing the hybrid 2.7i which will make more than 10hp un-tuned ;)

Go with a whodwho megasquirt setup instead but everything else looks good. I run everything you mentioned minus the throttle body and love it.

[Danny]

How are you going to fit two hundred and eighty cam shafts into an m20 cylinder head?

[mbonanni]

Danny, I am not sure if you are trollin or what.

But isn't 280 cam some type of aftermarket cam?

[Cronopoulos]

Danny, I am not sure if you are trollin or what.

But isn't 280 cam some type of aftermarket cam?

For sure. OP said cam(s) for the m20, simple error..... we hope ;)

[mbonanni]

gotcha

[BavBeater85]

oh yeah, my bad...met cam, used to my old eclipse....nah, Myster E said he'd grind cam to spec, and obviously a 288 would be a bit aggressive but Ive hear w/o proper work 272 isnt agressive enough...as far as the 2.7 build, thats also a possibility because I still have my old eta block from my motor swap...just lookin for possibilities...shes got pep but i want more, swapping an e for an i probably wasnt the best choice, but I was looking for the most power with least fab work

[BavBeater85]

may have to just boost, cuz I love the handling of this car after the suspension upgrades, but miss the raw spooling power of my eclipse...still gonna need the head work though, but i guess in that case I would just go with like 272 or 274 ground camshaft

[Robotin]

with a aftermarket cam and boost, u wont have to put down an ass load boost and still make enough HP.