Announcement

Collapse
No announcement yet.

Stock M20 deck height

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Stock M20 deck height

    Ok guys, what is the stock deck height for an M20?

    I'm reading 206.2 in some places, 206.7 in others. Still other people are claiming 2.7 block is 206.2 and 2.5 is 206.7

    What's the verdict? Who has actually measured the deck height, and what did you find?
    Drive it hard. Maintain it well.


    Convertible Technical & Discussion
    A Topless Memorandum

    #2
    ive measured two b25 blocks recently both 206.2mm. even eta block wasnt 206.7, it was 206.0 iirc
    Last edited by digger; 12-02-2015, 05:01 PM.
    89 E30 325is Lachs Silber - currently M20B31, M20B33 in the works, stroked to the hilt...

    new build thread http://www.r3vlimited.com/board/showthread.php?t=317505

    Comment


      #3
      That's what I was thinking. M20 B25 8.8:1 pistons, stock crank and stock 135 rods sit at 206.7, 0.5mm over deck height according to your measurements. Sounds like people have been confusing the piston height with the deck height.

      So 206.2 it is. Anyone measure a stock block differently?
      Drive it hard. Maintain it well.


      Convertible Technical & Discussion
      A Topless Memorandum

      Comment


        #4
        you should always measure the block you plan to use anyway as it may have been machined previously and there may be some variations
        89 E30 325is Lachs Silber - currently M20B31, M20B33 in the works, stroked to the hilt...

        new build thread http://www.r3vlimited.com/board/showthread.php?t=317505

        Comment


          #5
          Of course. Assumptions bend valves, or worse!
          Drive it hard. Maintain it well.


          Convertible Technical & Discussion
          A Topless Memorandum

          Comment

          Working...
          X