So while my block and head are at the machine shop I decided to rebuild my lifters.
I Did some researching and found out how to get them apart but I've hit a road block.
After smacking them on a wood block and getting the center bit out, everything I've read says the piston in the center part should just pull out easily. However it seems that there is a clip that is holding the piston in on these.
Has anyone rebuilt theirs? How did you get them apart?
I Did some researching and found out how to get them apart but I've hit a road block.
After smacking them on a wood block and getting the center bit out, everything I've read says the piston in the center part should just pull out easily. However it seems that there is a clip that is holding the piston in on these.
Has anyone rebuilt theirs? How did you get them apart?
Comment