Interest in Bolt on Turbo kit?

[jntar]

I apologies in advance for not reading though the whole thread since I'm on my phone but are you offering the dme separate?

He does offer a turbo chip separate. I am running it in my turbo car currently. PM him and he will give you details.

[PFCRayB]

Do you mind if I ask a few questions on your car

[jntar]

Do you mind if I ask a few questions on your car

Ask away.

[PFCRayB]

The basic is what's your set up, my old set up was a internally wastgated t3 turbo, running 16psi, a rrfpu, stock dme, and I can't remember what injectors I had

[jntar]

The basic is what's your set up, my old set up was a internally wastgated t3 turbo, running 16psi, a rrfpu, stock dme, and I can't remember what injectors I had

TD04-15g internal WG
NXS Signature Manual boost controller
9psi
running a bosch recirculating valve
42lbs injectors

[PFCRayB]

I had a 1g dsm bov

[jntar]

I had a 1g dsm bov

With Jake's tune you will need to recirculate the BOV. Since it uses the stock AFM pre-turbo, it's already metered the air and will go very rich once you're off throttle. It would probably still work vented to atmosphere, but would likely die when downshifting or coming to an idle from higher RPM.

[PFCRayB]

Maybe that's why it backfired everything I was off throttle.....since I didn't build the motor I ended up lifting the head since the guy I bought the motor from didn't use Apr studs like he told me.....

[Balleristic31]

With Jake's tune you will need to recirculate the BOV. Since it uses the stock AFM pre-turbo, it's already metered the air and will go very rich once you're off throttle. It would probably still work vented to atmosphere, but would likely die when downshifting or coming to an idle from higher RPM.

Where do you recirculate it to?

[jntar]

Where do you recirculate it to?

Back in pre-turbo/post AFM.

[thomas88162]

You are not that far away...come up this summer and I'll make a manifold off your car.

...You are certainly tempting me.

[bmwm42]

Back in pre-turbo/post AFM.

Could you post a pic I'm also buying the chip separate

[jntar]

Could you post a pic I'm also buying the chip separate

Old turbo with same diverter valve setup.

[Balleristic31]

Is it plummed to line coming out of the compressor?? Not seeing how that would work otherwise.

[jntar]

Is it plummed to line coming out of the compressor?? Not seeing how that would work otherwise.

Yes, it's connected to both the intake side and compression side.