Snapped off a hollow turbo inlet oil fitting on the back of my block. Can't get it to come loose with an easy out. Can't get a drill down in there. Anyone have an idea other than pulling the motor? Not been my day today...
Announcement
Collapse
No announcement yet.
Snapped oil fitting. Ideas to remove?
Collapse
X
-
90 degree drill adapter from Harbor Freight and a left hand thread drill bit? you might have to grind the drill bit shorter for clearance and pack the opening with grease so no chips go the wrong place. Is the fitting brass? Anything hanging out at all that could be hit with a chisel to loosen it up a bit?
Comment
Comment