I am building a stroked m42. My crankshafts are already on the boat from europe. I need to get the pistions and rods.
Question is should i go with 140mm or 135mm rods.
Ill be running 9 or 9.5 compression, e85 and fairly large amounts of boost. Rev limit will be set to 7.5k rpm.
longer rods will place the pin higher in the piston and probably reduce some crown thickness.
Whats your opinion?
thank you
Question is should i go with 140mm or 135mm rods.
Ill be running 9 or 9.5 compression, e85 and fairly large amounts of boost. Rev limit will be set to 7.5k rpm.
longer rods will place the pin higher in the piston and probably reduce some crown thickness.
Whats your opinion?
thank you
Comment