I'm trying to figure out what causes the driveline clunk on my car. It's only happening on low (around 1000) rpm and on very little throttle input. I recorded a little video to show the clunk:
This is a very mild example, sometimes the clunk gets very bad to a point where the car heavily bounces forward/back. This gets super annoying when sitting in LA traffic on a daily basis.
I just got the car a few months ago and changed:
I noticed that there is a good amount of transmission output shaft play (maybe around 10degrees) I'm not sure if this is within spec or not.
I visually inspected the subframe mounts and they seem OK. I can't hear nor feel any clunks when going over bumps, so I assumed it must be driveline related.
Thanks for your input!
This is a very mild example, sometimes the clunk gets very bad to a point where the car heavily bounces forward/back. This gets super annoying when sitting in LA traffic on a daily basis.
I just got the car a few months ago and changed:
- Flexjoint
- Center Support Bearing
- CV axles
- Rear shocks + mounts
- Swaybar endlinks
- Swaybar bushings
- Transmission Crossmember and mounts
- Diff mount
- cleaned ICV (car idles fine)
I noticed that there is a good amount of transmission output shaft play (maybe around 10degrees) I'm not sure if this is within spec or not.
I visually inspected the subframe mounts and they seem OK. I can't hear nor feel any clunks when going over bumps, so I assumed it must be driveline related.
Thanks for your input!
Comment