M60b44 #

[driftingminor913]

Also I have Been practicing my TIG so I can weld up my headers and make my down pipes.

[Jean]

FINALLY THE LAST PEICES!

What specific set (sizes) did you end up getting?

[driftingminor913]

Just the regular size, 5/8ths?

[Jean]

for front/rear/and clutch?

[driftingminor913]

Yeah

[driftingminor913]

Started the passnger side first for the headers, lol I am no means an amazing welder and this is my first time TIG welding anything so sorry if it's not up to awesome quality haha















going to try and finish the driver side sometime this weekend. After that will start on the install of the brakes.

[driftingminor913]

Finished other side, which was much easier the second time around

on to getting the brakes and everything

[JCarp90]

See what happens when you have a little bit of supervision?

[Vtec?lol]

Unless that engine is going in at a crazy angle or you've graduated cum laude from hogwarts.... There's no way those headers will work in an e30.

[Jean]

Run that shit through the firewall/cabin/out back :) j/k

[driftingminor913]

Lmfao, will do

[JGood]

Yeah, those headers, as is, will basically be butted up against the firewall. I don't even think there's room for a sharp 90* bend at the end of them. The only place for the downpipes in an m60 e30 is tucked right up against the bottom of those loops on the side of the block (where the starter goes). Literally, right up against them.

[driftingminor913]

Has anyone yet to find a build thread with the M60b44 swap? That was dynoed? I'm still curious about the power n what I'm getting into

[Yorl]

The only place for the downpipes in an m60 e30 is tucked right up against the bottom of those loops on the side of the block (where the starter goes). Literally, right up against them.

Yup, that's how my longtubes run. It's not easy, not a lot of room with the starter and the stupid steering column....

[driftingminor913]

Yup, that's how my longtubes run. It's not easy, not a lot of room with the starter and the stupid steering column....

I know it won't be easy but I will get it too work