my old aux fan died and was replaced. it works on low speed fine but not high speed when jumping the rad temp switch (dual temp version).
i have checked pin 30 is hot at K6 relay and it is just like K1
The relay itslelf works tested several relays in fact, and can here them click when jumping the rad temp switch
The issue is there is no power getting to fuse 18 from K6-pin 87. how do i get into the fuse box to check ? it looks like some kind of circuit board and access is non exsistant
i suspect when the 30A fuse when fan failed it took out the connection between the fuse and pin87 of relay K6

i have checked pin 30 is hot at K6 relay and it is just like K1
The relay itslelf works tested several relays in fact, and can here them click when jumping the rad temp switch
The issue is there is no power getting to fuse 18 from K6-pin 87. how do i get into the fuse box to check ? it looks like some kind of circuit board and access is non exsistant
i suspect when the 30A fuse when fan failed it took out the connection between the fuse and pin87 of relay K6

Comment