Share your 5 lug setup and wheels

[Aptyp]

I have camber plates, and I haven't installed e36 m3 control arms yet. So there's the look, if you don't install 96+ m3 control arms. I got the arms (ball joints installed), but haven't had enough time to install them yet. In a few weeks, I'll get it knocked out.

[Gooch]

-e30 m3 5-lug
-BBS RC090's e39 fitment (anti rattle clips in)

You beat me to it...I'll be getting mine on in a few weeks. Looks great. How'd you get them to fit with the rattle clips? Spacers? What size tires are you running? I just ordered a set of 214/40 Falken 912's.

[e30s52]

You beat me to it...I'll be getting mine on in a few weeks. Looks great. How'd you get them to fit with the rattle clips? Spacers? What size tires are you running? I just ordered a set of 214/40 Falken 912's.

215/40 I think. The front I have the rattle clips in but my break pads are worn down to about 50%. On the rear I now have 3mm spacers and it fits perfect with my fenders. Now my fenders are rolled flat but even without spacers you will need to roll your fenders.

I hope this helps

alex

[Gooch]

Thanks a bunch Alex, I appreciate it.

[e30s52]

No problem, The rear of my car is finnaly starting to settle down so it doesnt sit so damn high.

[daniel]

No problem, The rear of my car is finnaly starting to settle down so it doesnt sit so damn high.

more pics of redefined hood?

[e30s52]

more pics of redefined hood?

It gets more redefined each day it I go to work. Its rust/paint/metal. I am redefining hoods.

But I really do hate the hood with a passion. I have been to lazy to look for a new one.

[mw044]

E30 325ix

Front:
-e87 (1 series) rear hubs
-e46 330i/d discs (325x25)
-e32 735i calipers

Rear:
-e36 compact rear hubs
-e34 m5 discs + calipers (300x20)

Wheels MOMO arrow 8x17" et15 (too small ET for ix - torque steering issues)

Will post pics later...

[asubimmer]

1 series rear hubs on the front?

[mw044]

1 series rear hubs on the front?

Yes. Notice that car is iX. Front hubs in ix are same type as rear hubs. The reason to use 1-series hub is, because it is only 10mm wider than ix stock hub. For examle e30 m3 rear hub is ~20mm wider.

[blueapplesoda]

^^ interesting.

[daniel]

^^ interesting.

+1!

[decay]

mw044: we demand pics, sooner than later. :)

[asubimmer]

Yes. Notice that car is iX. Front hubs in ix are same type as rear hubs. The reason to use 1-series hub is, because it is only 10mm wider than ix stock hub. For examle e30 m3 rear hub is ~20mm wider.

weird, makes sense though if you think bout it.

[Aptyp]

that really is the most interesting setup so far, I am very tuned in to see pics.

TI hubs wouldn't fit into IX bearings, did you have a spacer machined?