Control Arm Replacement

[DarkWing6]

When I am replacing my front control arms do the bolts need to be torqued or do I just go as tight as I can?

Derek

[hamann318is]

Bentley has all the torque specs.

The only problem would be with the subframe mounts anyway, but it's doable.

[DarkWing6]

I don't have a Bentley and I will be doing this before I can get one....could someone please post the torque specs.

[parkerbink]

Here you go:

[M-technik-3]

I don't have a Bentley and I will be doing this before I can get one....could someone please post the torque specs.

Buy one please.... $29.99 through Blackforrest with $6.00 dollar mailing cost or buy one thru Amazon.com and pay roughly the same.

[DarkWing6]

I'm going to, but my control arms need to be replaced. I will prolly pick one up in the next month or so.

Thanks for the specs!
Derek

[atmh]

Or you can try the local bmw parts shop. When I went to buy the first replacement parts for my car, I also bought a bently book, they had it right in stock. Pretty good price too.

[Digitalwave]

Pretty much every bolt on the car needs to be properly torqued.

[cthulu703]

I got mine at the BMW dealership and it didn't cost anymore than anywhere else. They have them in stock att Ramussen BMW over on SW Jefferson PDX.