Losing pressure after 20 minutes probably isn't a problem anyways. Running rich would be, but that could be a lot of different issues.
Injector service?
Collapse
X
-
-
I did the same shit...9volt battery too.Hooked up a fuel injector can to a hose that fit on injector. Injectors seem to fire good. New pintle caps and filter too.
dlm ny countryComment
-
I practice prevention.
First when its hot outside and the car is hot lift the hood. That "corn" gas will get sticky.
Second , once or twice a year use
Sea Foam additive , others are junk
Third, new filters (duh) and avoid short trips (duh)
Fourth .drive like hell.
Never had a problem.
.Comment
-
As others have stated, fixing a stuck injector is going to be difficult to impossible. I will also mention a note with four-pintle injectors... when running them in my injector machine, I have noticed that all tend to spray directly downward. Our stock injectors actually spray the fuel at a slight angle towards the back of the intake valve. Realistically, if yours are leaking, I would say that it is time for a replacement set.Comment
-
I have used RC Fuel Injectors in Torrance, CA, to rebuild my injectors. They provide a written before and after report with detailed information, including spray patterns, etc. The shop was founded by the late Russ Collins and does great work
Comment
-
I am having a crank no start problem and I am wondering if this might be a fuel pressure problem. Has anyone here ever had this problem? Could it be spark plugs??
On several occasions my car hasn't started but when I hot wire the Fuel pump to a Battery and have it run for a few seconds, the car starts fine and runs without issue. Anyone experienced this ?
Of note (I don't think it's a fuel pump issue, I have a new fuel pump and changed it thinking that my fuel pump was dying).GK
Conformity is a crimeComment
-
Comment
-
That's highway robbery. The going rate is about $15 to $20 per injector to rebuild and flow test them.Comment
-
not sure running some cleaning fluid through them changing the o-rings, filters, caps etc classifies a rebuild lol89 E30 325is Lachs Silber - currently M20B31, M20B33 in the works, stroked to the hilt...
new build thread http://www.r3vlimited.com/board/showthread.php?t=317505

Comment
-
Comment
-
Well, been sick for awhile, so the 323i got put on the back burner. Did have someone test the electronics and we noticed when the car got warm the ecu went flat line for the injectors.
They were just open all the time. So now I have a new ecu and hopefully we will get the h23 back on the road this week.
Comment




Comment