This bloody mess of a thread is brought to you by Kotex.
-
-
Learn to attach pictures or something
Comment
-
sigpic
1987 - 325i Convertible Delphin Auto [SOLD], 325i Convertible Delphin Manual [SOLD]
1989 - 325i Convertible Bronzit m30b35 swapped [SCRAPPED], 325i Sedan Alpine Auto[DD]
1991 - 325i Coupe Laguna Manual [Project], 535i Sedan Alpine [SCRAPPED]Comment
-
The only reason I'm hanging around is to see if the damage in any way resembles the description.S52-Powered 1987
sigpicComment
-
yup, you broke shit.sigpic
1987 - 325i Convertible Delphin Auto [SOLD], 325i Convertible Delphin Manual [SOLD]
1989 - 325i Convertible Bronzit m30b35 swapped [SCRAPPED], 325i Sedan Alpine Auto[DD]
1991 - 325i Coupe Laguna Manual [Project], 535i Sedan Alpine [SCRAPPED]Comment
-
just put some duct tape on it
Originally posted by ROLLingKINGOriginally posted by slammin.e28Comment
-
your spring brokenLorin
Originally posted by slammin.e28Comment
-
ok so where do i go from here? by spring do you meen the shaft or the spring in the picComment
-
just get a new boot to keep the grease in and you're good to go.S52-Powered 1987
sigpicComment
-
kinda hard to tell from pic. if you grasp the shaft on the greasy end (ahem) and try to move it radially ( up and down , front to rear) does it move ? the shaft should only be able to move longitudinally ( from one CV joint towards the other)Lorin
Originally posted by slammin.e28Comment
-
I've got extra CV axlesComment
-
it shakes left to right , and how much were you willing to sell em for and are they fresh ? cause i was supose to get some from the junk yard, most of the cars there are jacked up so i think i would be able to tell if the axle is bad.Comment
-
of course it moves L to R, its supposed to. does it move up and down as well ?Lorin
Originally posted by slammin.e28Comment
-
it moves (as you if stood behind the car and you can pull it back in forth) but only about 1 inch of moving. and you hear a clunking in the joint.Comment
Comment