Carbon fiber parts for your E30

[FunfGan]

I would, if I had the money :P

[kamotors]

Sorry, I haven't made any progress, I used an entire yard just learning the tricks of the trade to get a nice sturdy product and now I broke, on the bright side I made an indestructible toilet paper roll;)

Is there any interest in a lightwieght pin on race trunk?

[Farbin Kaiber]

I was talking about the lip, it looks kinda wavy to me, maybe just camera or picture...

[Regnar75]

btw

btw you once posted "I've always wanted to see an E30 with a roof wing/deflector setup."
followed by a picture...

just sayin

[kamotors]

door cards will be vacuum bagged but not the rad covers

[Farbin Kaiber]

How thick is it? You are not vac bagging, are you?

[Regnar75]

shit i like it!!


ill even buy the plastic piece ..

how much?

this^ seriously KA, how much for the ABS plastic one, my radiator is bent up and id like a low profile cover just to hide it a bit and protect the top from any more damage and i dont care for too much CF.

[AE_m20]

but it would be around 200 each, you must remember that It needs to be more than one layer and the door cards are quite large.

Sounds reasonable. Also, unlike some of the others I'm not as picky about how aesthetically pleasing it is. As long as it covers most of the door and has a cutout for the stock door handle than its good enough for me.

[brainycheddar]

What about a CF headlight delete/venturi?would look sweet!

[kamotors]

Im still working on a good technique to make these efficiently but it would be around 200 each, you must remember that It needs to be more than one layer and the door cards are quite large.

[AE_m20]

Definitly in for door cards

[Vivek]

What would a ballpark price be for these things (splitter and door cards)?

[Regnar75]

Cup holder! I still have to wedge my beer between the pass. seat and center console.

+1

same technique

[FunfGan]

how about a rear speaker shelf out of CF that also gets rid of the speaker holes and seatbelt mounts for race cars or those with roll bars? maybe even delete the third brake light?

I really like this, and the single panel door idea(not contoured, but still retains original door handle). The rear decklid would be great, seeing as I'm using a spray painted one just to keep the glare down from sound deadening...

[jaywood]

You should make the parts from fiberglass, just make the first layer carbon fiber. That way the parts don't cost a billion dollars

Also, if you only do 1 layer of CF the fiberglass will show through the CF weave