Presto! A Rear M3 Seat!

[archie]

Any pictures of the seat back?

No I don't have one, wishin I took at least one. Bummer cuz it's in the car now.

[Asbradley21]

Any pictures of the seat back?

[dannyyisntt]

What he said ^

[graveshaker]

Looks damn good no matter what.

[archie]

The seat look great! Just not original. What color is that? I am kinda diggin it!

Thank you and as far as I know I asked and was given Cardinal, if its of a bit then it's off a bit. Sorta kinda stuck with them now.

[Van Westervelt]

Hah, we both referred to the difference as 'pronounced'

[Van Westervelt]

The middle of a true m3 seat is actually a hard shell though, not just bare foam. And the buckets are quite a bit deeper and more pronounced than these.

The seat look great! Just not original. What color is that? I am kinda diggin it!

the only problem would be to locate the rear seatbelt plastic holder thing. Don't think you can buy that. looks like it shoud turn out pretty nice.

I think you could just remove single receptacle and move the double one to the middle.

The problem is that the M3 has a reinforced bolt hole in the center, while the non-M cars have two on either side.

Most people don't care about that...they just want an M3 looking rear seat.

The plastic part Mike is talking about is the same part that standard seats have off center. The reinforced bolt hole can be welded in no problem and is completely separate from the seats, so thats a non issue.

[reelizmpro]

Shant, good seeing you last night. Sorry I was short on time. In regards to the seat, they needed to make the bolsters more pronounced and squared off. There's also an extra cushion on the edge under the knee area.

[archie]

Looks good in that colour.
Did the guys have an M3 seat to work too??
As I notice, the front of the base is not "Square"

They had a photo they looked at printed from the internet.

wow. how much?

Call and speak to Sergio, ask him.Tell him Archie sent you.
(714) 279-2990

[flyboyx]

wow. how much?

[rav320uk]

Looks good in that colour.
Did the guys have an M3 seat to work too??
As I notice, the front of the base is not "Square"

[AndrewBird]

Looks nice. Great color choice!

[archie]

Few more pics of the rear seat just about finished.




And a photo of the guys working on the back part of the rear seat when I showed up.

[reelizmpro]

Most people don't care about that...they just want an M3 looking rear seat.

[MaxBell]

I think you could just remove single receptacle and move the double one to the middle.

The problem is that the M3 has a reinforced bolt hole in the center, while the non-M cars have two on either side.