Announcement

Collapse
No announcement yet.

I think the Ford 2.0L I-4 EcoBoost might be a good E30 engine

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    I think the Ford 2.0L I-4 EcoBoost might be a good E30 engine

    Seems like the small lightweight turbo 4-cylinder from the Ford Focus ST would be a good candidate for an E30 swap. Ford Racing sells a crate engine and also an ECU and wiring kit . It looks like a salvage motor pulled from a 2013-14 ST runs about $3k. Mated up to a 6-speed I think it'd be pretty awesome.
    Plug and Play Wiring Harness Adapters for S54, S50, M54 and more.

    #2
    Originally posted by Andrew325is View Post
    Seems like the small lightweight turbo 4-cylinder from the Ford Focus ST would be a good candidate for an E30 swap. Ford Racing sells a crate engine and also an ECU and wiring kit . It looks like a salvage motor pulled from a 2013-14 ST runs about $3k. Mated up to a 6-speed I think it'd be pretty awesome.
    I'd agree. depending on the complexity of adapting it to rwd it would be a monster. Few local guys have those ST's wrapped up over 300whp.
    sigpic

    Rebellion Forge Custom Fabrication

    1988 325is - TrackRat in progress

    Instagram @rebellionforge

    Comment


      #3
      I wouldn't think it'd be too hard. The rear-wheel-drive Ford Falcon in Australia uses it. :)
      Plug and Play Wiring Harness Adapters for S54, S50, M54 and more.

      Comment


        #4
        Would like to see someone try this. Crate motor is like $7k so I doubt someone in here will. They are like 250hp from the box though.

        Comment


          #5
          Originally posted by IDM View Post
          Would like to see someone try this. Crate motor is like $7k so I doubt someone in here will. They are like 250hp from the box though.
          Solution
          1. Buy $500 beater
          2. do not license or insure
          3. target Focus ST
          4. smash said beater into focus ST
          5. Flee the scene by foot, air or donkey
          6. watch local insurance action
          7. PROFIT
          sigpic

          Rebellion Forge Custom Fabrication

          1988 325is - TrackRat in progress

          Instagram @rebellionforge

          Comment


            #6
            That's actually kind of genius in an incredibly stupid way. I like it.
            For all things 24v, check out Markert Motorworks!
            Originally posted by mbonanni
            I hate modded emtree, I hate modded cawrz, I hate jdm, I hate swag, I hate stanceyolokids, I hate bags (on cars), I hate stuff that is slowz, I hate tires.

            I am a pursit now.

            Comment


              #7
              Originally posted by Andrew325is View Post
              Seems like the small lightweight turbo 4-cylinder from the Ford Focus ST would be a good candidate for an E30 swap. Ford Racing sells a crate engine and also an ECU and wiring kit . It looks like a salvage motor pulled from a 2013-14 ST runs about $3k. Mated up to a 6-speed I think it'd be pretty awesome.
              Robert (peerless) has done this. I cant remember the outcome. I will try to find the thread.
              "Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery." - Winston Churchill

              "People sleep peacefully in their beds at night only because rough men stand ready to do violence on their behalf" -George Orwell

              Comment


                #8
                Originally posted by sir otto View Post
                Robert (peerless) has done this. I cant remember the outcome. I will try to find the thread.
                Subscribed for link, I want to read this.
                How to remove, install or convert to pop out windows
                http://www.r3vlimited.com/board/showthread.php?t=297611


                Could be better, could be worse.

                Comment


                  #9
                  Pretty Awesome:

                  252 Horsepower @ 5,500 RPM
                  270 lb. ft. of torque @ 3,000 RPM
                  When used with Engine Control Pack M-6017-20T and 93 octane unleaded fuel, torque is increased 90 lb. ft at 2800 RPM - with a significant increase up to 4200 RPM.
                  All-aluminum construction - about 55 pounds lighter than a comparable naturally aspirated V6 engine

                  Comment


                    #10
                    What about the Chevy ecotech motor? Came in rwd on the Pontiac solstice so transmission is less of an issue.

                    -NICK

                    Comment


                      #11
                      Oh, there's also the 2.3L version. It's even better. :)
                      Plug and Play Wiring Harness Adapters for S54, S50, M54 and more.

                      Comment


                        #12
                        I think the Ford 2.0L I-4 EcoBoost might be a good 2002 engine
                        We can serve you better through Email

                        sales@blunttech.com
                        www.blunttech.com


                        Like us on Facebook

                        Comment


                          #13
                          Originally posted by blunttech View Post
                          I think the Ford 2.0L I-4 EcoBoost might be a good 2002 engine
                          Oh god that would be a rocket ship....


                          1989 325is l 1984 euro 320i l 1970 2002 Racecar
                          1991 318i 4dr slick top


                          Euro spec 320i/Alpina B6 3.5 project(the never ending saga)
                          Vintage race car revival (2002 content)
                          Mtech 2 turbo restoration
                          Brilliantrot slick top "build"

                          Comment


                            #14


                            Somewhat relevant EcoBoost into a fox body.

                            Comment


                              #15
                              This would be cool.

                              Comment

                              Working...
                              X