If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Ohhhh I think I remember you from the boards now. I registered there a long ass time ago then switched accounts to !RocknE30!. I just lurk over there every now and then since I don't have a 240 and can only really contribute to the OT section :)
I'm 240sx2nr95 on there and NICO... I think I remember seeing u on occasion there. I was the sole guy organizing and coordinating all the westside meets, if that helps, lol.
Originally posted by lucky7
anyhow, good luck with your build dan. im tapped out of money, how about you?? lol.
-Dane from nico.
Dane, boy do I hear ya, this stuff is expensive! But if it's done right, it's worth it! Good luck with the swap, keep me updated!
Originally posted by E30_pilot
mmm rb25...are you still running a KA?
What suspension you running?
Yup, still on the KA right now with some goodies until the RB25 is done. As far as suspension goes, right now it's just Sprint springs, AGX adjustables, Cusco front strut bar, Cusco RUCAs, SPL pillowball tension rods, SPL aluminum subframe collars, OE rear sway bar with new bushings (base models didnt come with rear sways), Megan racing C-pillar bar, Moog outer tie rod ends (which suck). When money's availiable, I'm finally getting much needed coilovers. Still a few things in the suspension that i'd like to replace...
Comment