If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Seriously... who runs staggered wheel widths AND diameters? GHEY.
NSX drivers.
DUH.
This looks rad like an NSX.
DUH.
On a serious note (though I was being serious about alot of NSXs being on staggard diameters) I kinda like the tail lights. They aren't as bad as I would have expected.
RIP e30 (brilliantrot '91 325i) 11/17/06 Byebye: 8/21/07
Welcome e30 (brilliantrot '90 325is) 12/23/06
DaveCN = Old Man
My signature picture was taken by ME! Not by anyone else!
Originally posted by george graves
If people keep quoting me in their sig, I'm going to burn this motherfucker down.
On a serious note (though I was being serious about alot of NSXs being on staggard diameters) I kinda like the tail lights. They aren't as bad as I would have expected.
Well said.
My only real qualm with the car I think is the varying bumper strip moldings. If you could get the M3 front bumper to have the same width of black moldings then I think it would look much more uniform. Maybe also use E36 M3 side moldings so the thick line is continious? I don't know, just my thoughts.
Comment