Kamotors E30-Turbo to ITB M20
Collapse
X
-
Running great, getting close to releasing the turbo setup as a kit.
Sent from my SM-N920T using TapatalkLeave a comment:
-
-
Nice. Can't wait to see the kit on the site and start budgeting, haha.Leave a comment:
-
Leave a comment:
-
Loving the build!! Good to know that manifold can hold boost because I’m going to go rotrex on my e30. Initially going 6lbs and then I’ll throw some itbs on.Leave a comment:
-
So car held up to abuse all day. Making around 9psi, car is able make 4-5psi at like 1/8th throttle which is awesome.
Sent from my SM-N920T using TapatalkLeave a comment:
-
So only leak that developed was between plenum and backing plate at around 6psi, but I only had a black rtv seal so it was somewhat expected, I did have to cut the rtv around the entire border to get it free from the backing plate it was stuck on there pretty good everywhere but one spot. This time I went with a felpro .063mm gasket I cut and then used black rtv as additional assurance. Will test drive in the morning, hoping it'll hold at minimum 9psi. Car is very fun to drive as it has that crisp n/a response but with all the glorious boost noises.


Sent from my SM-N920T using TapatalkLeave a comment:
-
dats some sweet eye candy. Plenum should hold up fine, just wondering about sealing to the trumpets thoLeave a comment:
-
Finished tuning today, only a few bugs to work out and then I can see what kind of boost this setup will hold. External wg is set at a higher pressure than the internal there for does not open.

Sent from my SM-N920T using TapatalkLeave a comment:
-

Leave a comment: