Melted a piston, now LSX Turbo

[Dirk HX35]

Lots of parts coming tomorrow, the end is near.
2 years later and the car is just about ready to go soon.

[lambo]

ugh yiss

[CRBR30]

I think you're the only one who can pull off those headlights lol

[Dirk HX35]

I think you're the only one who can pull off those headlights lol

Thanks haha I think it will look even better all one color and finished up.
Some more parts showed up and my rear lips did too.

[Dirk HX35]

Yeeeaaaaahhhhh baby
Gotta take a little camber out and pull the fenders some more

[pputkowski]

This is the most wtfawesome build I've seen on here.

[E30_Pare]

I like the two tone mtech thing goin on here. Lol.

[Dirk HX35]

Just need to make lines once the motor is in again.

[IronFreak]

What are you going to use for lines and do you think the LS pump has what it takes to run that rack?

[Dirk HX35]

6an Teflon for the pressure side and normal 6an for the low pressure side.
Plenty of guys use the camaro pump in their e36s and this is an e36 rack so I don't see any problems with it. We will see

[325ix]

Wow, this thing looks killer. Can't wait to see it all finished up.

[Dirk HX35]

Finished the stage 2 rebuild, hope it holds together for a while.

[Good & Tight]

Godamn I love this build..!! Makes me a want turbo v8....to be honest I secretly yearn of building one.

Will you have to massage the firewall/foot well area to fit the trans?

[Dirk HX35]

Godamn I love this build..!! Makes me a want turbo v8....to be honest I secretly yearn of building one.

Will you have to massage the firewall/foot well area to fit the trans?

Thanks Otis, I cut down the reverse lockout and welded a cap on the back so it has a smaller profile because it hit the trans tunnel. I need to "clearance" the trans tunnel in one spot and it's all set.

[CRBR30]

gawd dayum I love this build