Taco's hopes and mostly dreams.

[dugly52]

Updates?

[TheTacoMan]

Thats a big turbo, still I wonder how long that lasted.

[Nisse Järnet]

That thing made 647whp?! AND like 790nm of tq (roughly 580ft.lbs.)

Yep, don't know for how long though :)

[IronFreak]

That thing made 647whp?! AND like 790nm of tq (roughly 580ft.lbs.)

[Nisse Järnet]

Thread: http://server.pure-pf.com/phpBB/view...hp?f=2&t=41398

[Nisse Järnet]

That's a Swedish car, the nozzles were for N2O but wasn't used.

[IronFreak]

Two BOV's and No2 injection or is that meth? impressive, like his vac lines ahaha no BS, straight to the point haha!

[stanhayward]

Thanks! So Nisse where did you find the m20s stock bottom end limit?

I never did, i upgraded before it broke :)
First M20 setup was with M50 rods (nv i think) and shaved stock pistons, o-ring head gasket. Drove it like that for 2 years with 430whp without issues then sold the internals. (still looked great!)

The head had stainless +1mm valves, harder springs, Nuke billet rockers and a Z45 cam.

the mystery continues.... still havent ever found the limit of the bottom end on M20's

I think this is the most. Not technically 100% stock bottom end (milled pistons to 8.2:1 CR), but it counts in my books and is thoroughly impressive.

http://www.maxbimmer.com/forums/showthread.php?t=142462

[TheTacoMan]

:42 and 1:10....yiiiissssss

[IronFreak]

:42 and 1:10....yiiiissssss

[TheTacoMan]

Video of Car meet

[TheTacoMan]

3rd gear pull was basically even, pulled about a car length if that at 15psi in the e30.

[2mAn]

Weistec Supercharged benzes are no joke.

[TheTacoMan]

Cars and coffee today, the c63 amg I pulled a bit was there too.
700hp and the little e30 that could

[Nisse Järnet]

the mystery continues.... still havent ever found the limit of the bottom end on M20's

People here seems to brake rods ands pistons on stock engines around 500hp.