Matracer's project: BRONZIT S52 - DYNO RESULTS P.8

[Sh3rpak!ng]

love seeing another bronzit s52!! looking good, get a skid plate on there pronto!

[MatRacer]

It was sunny on sunday! Took the Bronzit and the camera out:















Far front perfect, but I like it!

Edit, Just noticed its my 500e post!

[MatRacer]

And yeah, it is a local scale used by transport regulation

[MatRacer]

Im so confused by this hahah

Right side is 580kg
Left side is 290kg
??

where is this scale?

Left is 610Kg total with 290 rear and 320 front.

Right is 600kg total with 290 rear and 310 front.

The first shot is 640 front axle, 580 rear axle...

Edit haha agree that it's wasn't clear at all!

[2mAn]

Went to the scale:
...
Pretty happy with the weight distribution.

Im so confused by this hahah

Right side is 580kg
Left side is 290kg
??

where is this scale?

[MatRacer]

Went to the scale:

Total weight:
front 640
rear 580
total 1220



Right:
front 310
rear 290
total 600



Left:
front 320
rear 290
total 610



Empty gas tank, spare tire in the trunk, no a/c, without me..

Pretty happy with the weight distribution.

[MatRacer]

Found this while cleaning the garage...always wanted to post it





Plastic hub centric ring... one got extremely hot!!

Also, got my driveshaft back... it still vibrate a bit, but I have my idea, will be back with more details

[2mAn]

Will look closer to sponsor next time I buy E30 stuff... good point... being in Canada is not the best for buying car parts...

I get it! I sold something to a member here Panici and it was a task to send him the parts

[MatRacer]

Will look closer to sponsor next time I buy E30 stuff... good point... being in Canada is not the best for buying car parts...

[2mAn]

I try to support the forum sponsors and he's local. Overall I like what Ive paid for. I hate waiting to install parts though, luckily its going down tomorrow

[MatRacer]

Bought the nut off Amazon.ca... had to buy tuner nuts because my said tuner wheels have just no clearance for standard bolts or nuts... does that makes me a tuner ?? :roll:

they seems to be pretty identical to the ones on Motorsport Hardware...

The studs are coming from Ebay... called the seller and they confirmed that they are grade 10.9 and that they are made in USA... The quality seems good and their store seemed to contain OK stuff.

Didn't know about Motorsport Hardware. Seems to be good quality.

[2mAn]

Looks like it will be a tight fit. I am a few days away from installing my studs. Did you get them from Motorsport Hardware

[MatRacer]

Meanwhile, received 90mm studs and open end nut!! Test fitted with the addition of 20mm spacers!! Final offset of et0 on 15x8 with 225/45 RS3





Pretty happy with the results! We will see if it rub or not...Also have a pair of 15mm spacer... maybe I will have to use then instead of the 20mm

Had rolled the fenders and cut the inner side back when I attended to fit too large wheel...

[MatRacer]

Installed and reved it to 80mph on jack stand before putting the exhaust back... it vibrates ... Will send it to rebuild shop...

[MatRacer]

Got my 328 driveshaft... inspected it: pretty tight... one on the four joints is kind of harder to move when you go max travel on each side... like is you bring it where it never been...

I will run it as is for a while and get it rebuilt if not good or in the next years...

A bit of cleaning: