What did you do to your E30 today?

[monty]

Installed quick release steering hub. I didnt like it so I took it off.

[dvmotorsports]

pulled my motor.

[Van Westervelt]

I put my coils back on, and e36 m3 brakes. lil other bits too. lol Spaced out the Breytons another 8mm. Looks amazing! 17x8.5 et13

[scott_is]

Grinded/Sanded my rear subframe for almost 3hours and I still have work to do
on it before I can paint it...

[e30pwr]

Gave it a good redline.....Oh and finally took some grime and shit off the rear diff...pending a new LSD unit.

[bimmer_E30]

got new stuff: muffler, mtech1 steering wheel. and JIM C comfort chip. cant wait!@!

[CorvallisBMW]

put in the new interior, looks HAWT :)

[scott_is]

Started buffing my front valance to find out that it has been smashed harder than the PO said. It had like a quarter inch of aftermarket rock guard+a shit load of bondo and rust of course.

And I got my Sways!!!!!!!!



And while I was putting the sways in the shelves I noticed that my bentley wasn't where it usually is....



Only to realise that I left it outside yesterday and of course it rained last night! I can be stupid sometime...now its like at least a half inch thicker now I just hope that it will still be holding up after it dries.

[dvmotorsports]

finished painting my motor

[z31maniac]

Picked it up from the shop.

[bimmer_E30]

painted my bumpers. and i am gonna drive it now.

[delphini]

On zinno , i got a few trim clips and re attached the fender trim , and continued to work on the intake... finished port-matching the intake yesterday.

[desertvert]

My euro trim and Kopi smoked turns (fronts) came in, got the new soft top waiting at the post office, and new-to-me carpet on the back patio. Now I have to wait two weeks until we move into our new place with the garage and I'll finally be able to work on the car again.

[TwistyTunedE30]

Well this event took place over tuesday and wednesday, swapping the suspension between the 318is and the 335i, I destroyed both the control arms and the tie rod ends on the 335i so i had to get more on wednesday, along with m3 cabs. its amazing how much lower the billy's and the springs sit with a 333lb engine instead of a 150ish one lol. I also swapped out the stock shifter with the b&m ssk.

[TwistyTunedE30]

Starting at 0800 this morning untill 1030, I pulled and reinstalled a new uncracked dash, omfg teh hotness, also reset the ecu and found all my lost power from trouble shooting o2 sensor.