Acceptable and Unacceptable Harbor Freight Tools

[slammin.e28]

Whelp, here it is. Hauled an m30b34 no problemo from my friends shop to my house.



Didn't sag or anything when loaded. No rocking, bouncing etc. For $55 shipped with 20% off can't go wrong.

[Onizukachan]

Word. May just splurge on the Craftsman set they have at Sears for like $60.

Do need something. I always seem to get water into new, electrical places each time I go 4x4ing.

For something like that,the stanleysets at walmart are a good deal. Or even the autozone set... Think they were $20?

[AwakenNoMore]

Broke a wobble head extension at the junkyard today trying to remove a wheel. wasn't using a breaker bar or anything. Probably nut the best extension choice so could have just been me being dumb.

What impact guns are you guys using from them?

[bernzpeed]

Broke a wobble head extension at the junkyard today trying to remove a wheel. wasn't using a breaker bar or anything. Probably nut the best extension choice so could have just been me being dumb.

What impact guns are you guys using from them?

i've broken a few of these... but only because it's not rated for an air tool which i always use or my little impact gun.

i've broken a long ratcheting wrench as well but brought it back and they replaced it no questions asked.

[Sideways87]

The hose clamp variety pack is something to stay away from. They break before you get them tight!!!

Sent from my DROID RAZR using Tapatalk

[ajhostetter]

I replaced my trunk tire iron with their breaker bar and extension. I think it was like 11 bucks for both, and they work great.

[ajhostetter]

Anyone have experience with their wobble socket extensions? They have a coupon for $2, and I'm tempted.

[Mlarsen]

2 bucks for extensions? Buy them and if they suck throw them away.

[accident]

Anyone have experience with their wobble socket extensions? They have a coupon for $2, and I'm tempted.

I have them. Not terrible but the "chrome" plating will quickly come off the tips and cause sharp edges.

[ajhostetter]

2 bucks for extensions? Buy them and if they suck throw them away.

Noted.

[randomtask37]

has anyone bought any air compressor hoses that are worth the $?

edit: or the hose accessory kits? (http://www.harborfreight.com/17-piec...kit-68236.html)
seems like for 6 bucks you cant loose

[Exodus_2pt0]

Anyone have experience with their wobble socket extensions? They have a coupon for $2, and I'm tempted.

A couple posts up.

Broke a wobble head extension at the junkyard today trying to remove a wheel. wasn't using a breaker bar or anything. Probably nut the best extension choice so could have just been me being dumb.

What impact guns are you guys using from them?

[Jand3rson]

I bought a heat gun from them today and used it for about
an hour streight to get oil out of my wood riffle stock.

Has a High and low speed 1500w. Didn't blow up. IMO it's good for $14.

Same one I have. I use it for snowboard waxing, also for rolling fenders.

[slammin.e28]

This guy:

http://www.harborfreight.com/3-8-eig...ill-67474.html

....anyone have one? How is it? Really just need it to work once. Also, anyone who gas one, can you measure how deep the head is (giggity)?

I'm trying to get the broken off belt tensioner bolt out of the front of a 2000 Corolla's engine. I have very limited space unless I take the engine out. Looks like this may make it so I can just disconnect the engine mounts and pull up the front of the engine and drill that sucker, then hit it with an EZ out.

[SoEm0]

has anyone bought any air compressor hoses that are worth the $?

edit: or the hose accessory kits? (http://www.harborfreight.com/17-piec...kit-68236.html)
seems like for 6 bucks you cant loose

I have a section of their air hosing. The fittings on the end are the only thing I have had issues with. They tend to leak quite a bit after a short time. As for the accessory kit they work well. I still use most of the pieces. I did upgrade my air filler to one with a pressure gauge though.