
3M glue fitted the top and sides, let it cure.

Used some Gorilla super glue to hold the tabs down on the front and rear to make the curve of the seat. Looks stock! Used some leather that I had been saving.
This is just a picture of the 3M glue setting up with the sides tucked. The first picture is all finished after a LOT of pulling and clamping to get them to stay while the super glue cured.
Used a leather indentor to crease the lines on the top.

Talking about clogged jets...I went and picked up a Briggs and Stratton Filter. REMEMBER to fill the filter up and out till the top line has fuel out of it. Air will not travel back into the tank through the petcock filter.

Next on the list is:
-Side mirror
-Coilover shocks in the back
-Install new tires this Tuesday when they arrive.
-Make a custom plate holder
Leave a comment: