PNW Chit Chat thread

[bmwm42]

finally r3v is back up

[e30austin]

I almost died without r3v.

[OldDrunkenSailor]

Jon, give Gerber Motorsport in Ballard a call. They did my swap and have an awesome welder/fabricator on staff and can wend that up for you in no time.

[e30Rooster]

I was so bored at work, fb can only do so much

Sent from my C771 using Tapatalk 2

[kid325e]

Spotted my car in the March/April 2013 edition of Zundfolge. Just thought I'd share. Feels good man.

Sent from my Nexus 4 using Tapatalk 2

[1craze30]

Jon, give Gerber Motorsport in Ballard a call. They did my swap and have an awesome welder/fabricator on staff and can wend that up for you in no time.

Thanks! I'm gonna give em a call today. What am I looking at in terms of money's?


Jon

[kid325e]

They probably charge by the hour or at least have to lay their own eyes on it before you get a good idea of what it would cost!

Your best bet is to call them, see if you can swing by with the car, or send them photos of the damage?

Also, I see you in the photo in Zundfolge with your wife next to you!

[Twelvizm]

Newest bit of video work. Had to test out some new gear, and do a little wheel whoring.

https://vimeo.com/67422022

[OldDrunkenSailor]

Yeah, it's hourly, so if they put a plate in, I imagine that it won't take too long. They race prep F1 cars, built a Pro3 car (it's in the building, you oughta ask to see it), restore Corvettes, do just about anything you can imagine, so I'm sure that they'd figure out some way to do it that'll last.

[Pdxseth]

Facelift/poor mans euro bumper I almost complete! Just need to do a little more sanding an paint the trim

[e30austin]

Nice!

[Erik]

Nice!

.

[1craze30]

They probably charge by the hour or at least have to lay their own eyes on it before you get a good idea of what it would cost!

Your best bet is to call them, see if you can swing by with the car, or send them photos of the damage?

Also, I see you in the photo in Zundfolge with your wife next to you!

I saw that! She will tell me to delete that picture from the forums! Lmao


Jon

[AustinK425]

The stud is still in that sleeve. It may be seized, so I guess it's no go while I can hunt down a shop to get that welded back up. Fml!


Jon

Just call Steve...

Anyone know of any local part outs? Paolo what's the condition/status of the red ix?

[kid325e]

Just tell me what you're looking for. The red iX is all apart. As far as the drive train goes

Sent from my Nexus 4 using Tapatalk 2