If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
BMW E30/325i/E32/E34 1987-1993 MSPNP Gen2 Plug and Play ECU
have a old ECU sitting around collecting dust that I purchased new for a turbo m20 525 build which I've decided to leave NA. willing to get rid of it including a wideband and a tps with tps bracket from...
M20 3.0 stroker build - looking for advice from the M20 gurus
Hi all,
I'm planning an N/A M20 stroker and would really value advice from the M20 gurus here. I have quite a bit of engine building experience, but I'm new to the M20 and its quirks, so...
I have a left hand drive e30 touring and need to buy the right rear (boot area) rear window. I believe the part number is 51361947264. Does anyone know of one for sale?
FS: Porsche 944 Brake Booster and E32 Master Cylinder
I have a new in box Porsche 944 Brake Booster (ATE 300083) and E32 Master Cylinder (ATE 34311156643). Bought from FCP Euro for my S52 swap, but ended up going with a different booster setup.
...
M20 distributor limitations and timing advance effect on the spark
does anyone know what is a design gap between distributor rotor and cap posts for each cyl when rotor is just above it? I roughly measured both and it's about 2mm. Basically what I see with my cam at...
Looking for a response from people who own, have owned, or otherwise have direct knowledge of the Wiesmann hardtop. I purchased and just installed a used one on my '91 vert. But when it is bolted down,...
I've been searching for 8mm hub-centric spacers with a lip (I believe that's what they're called), along with extended lug bolts, in a 57.1mm centre bore.
Is there a go-to supplier for a complete M20 hose kit? I’m looking to replace all the rubber hoses under the hood and would prefer to get everything from one vendor rather than sourcing each piece ...
I have a freshly pulled B27 with a getrag 260 for sale. Both have roughly 250k miles but still run great. I have videos of it running just before it was pulled. I'm doing an engine swap so I no longer...
WTB: German project car, CA (Fresno), any condition, clean title, cash
Hey guys, I'm Zak, 17, in Fresno. Looking for a German project car to learn on and wrench on with a buddy. Got a welder coming and want to learn welding/paint, so rust, dents or non-running are all fine....
Ok to start of: the gauge is verified with an accurate pressure gauge and they line up perfectly after 50psi (comp. gauge is 300psi so less resolution than accurate test gauge). schreder valve is located...
Can Brake Balance Be Maintained E32 Master Cylinder?
I have a brand new ATE stock size MC and entirely refreshed brake system. All calipers were stripped, cleaned, and rebuilt and the rears were upgraded to solid bushings. New stainless hoses all around....