Hey guys, I have another one for you.
We're done with our swap and went to bleed the clutch yesterday but we're not getting any pressure. I thought I'd leave the line loose and gravity bleed it but even then. I'm not getting much fluid to the slave. When you press the pedal, air and some fluid comes out.
After that I used a vac pump to pull fluid through and got about 3oz out but the pedal felt the same.
THEN we did a reverse bleed and finally the pedal felt good. We confirmed that it was bled by doing a regular bleed with the clutch pedal and it was good to go. Well, about 30 min later we tried to drive it and again NO pedal feel at all.
I don't know if it can be a bad master or slave or something else. Everything is new since we did a auto to manual conversion.
Any ideas?
We're done with our swap and went to bleed the clutch yesterday but we're not getting any pressure. I thought I'd leave the line loose and gravity bleed it but even then. I'm not getting much fluid to the slave. When you press the pedal, air and some fluid comes out.
After that I used a vac pump to pull fluid through and got about 3oz out but the pedal felt the same.
THEN we did a reverse bleed and finally the pedal felt good. We confirmed that it was bled by doing a regular bleed with the clutch pedal and it was good to go. Well, about 30 min later we tried to drive it and again NO pedal feel at all.
I don't know if it can be a bad master or slave or something else. Everything is new since we did a auto to manual conversion.
Any ideas?
Comment