Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
My purple E36 coupe cracked there pretty aggressively....
- Likes 2
-
-
+1 to this, I'd avoid O/S diameter at all costs because it doesn't fit well and makes the car feel truck-y....
Leave a comment:
-
it's going to be a rover 4.0 with fresh liners.
I've been waiting to see this since your instagram post.
Not sure what Luther is up to offloading all this stuff, but I'll...
Leave a comment:
-
I have the old German Engineering group buy coilover conversion, 6" 450f / 4.5" 650r with GC race plates up front....
Leave a comment:
-
I have had two of those ebay shifters and they're utter piles of shit.
They should be secured into the shift carrier with a snap ring on the bottom, but if the installer doesn't understand...
Leave a comment:
-
Also not sure if there's any issue deleting the expansion tank in general, like what happens if you don't have it, how much typical volume changes between off/cold running/hot running and if not being...
Leave a comment:
-
I honestly have no idea if that port can be deleted or if it needs to be able to draw for the pump/be able to push air to the reservoir to bleed properly, etc., but it sounds interesting.
...
Leave a comment:
-
Yeah that's it.
Various sources for blockoff plates for the back of the head, but they're easy to make out of a flat piece of aluminum.
Then cut/plug or replace the reservoir...
Leave a comment:
-
Probably hood alarm switch, afaik the alarm was a rarely ordered dealer option, but most(all?) E30s have this connector tucked somewhere around the fusebox....
- Likes 1
Leave a comment:
-
-
Yeah I wasn't going to say shit, but I was also thinking it was weird to get that hot. I went the other way and was thinking too little timing, but I also have no idea how long they were on the dyno....
Leave a comment:
-
That jumper harness shouldn't make a difference. I think it's for a crank sensor recall. Hard to find info on it, but I think they changed the sensor and that harness hijacks +12V from somewhere (I think...
Leave a comment:
-
I had their subframe + RTAB in 95a on my old iX and they were great.
Have their 80a RTABs in my car now and they have been great.
The car already has solid diff/subframe mounts so they didn't...
Leave a comment:
-
I've heard they're less likely to crack and just by nature of being a repro casting, there's more meat to work with for porting and resisting typical damage.
That said, it's a lot of money....
Leave a comment:
-
The original cam sensors typically die from the wire insulation rotting away and the wires shorting together, giving messed up signal.
If it shorts the 5V to ground, it can mess up the 5V rail in...
Leave a comment:
-
I've seen diesels around, but I don't think they were sold in NA in any real volume (maybe not at all?) so options are either be a V8 or SCV6. I've heard the crank issues with the Diesels through LRTIME's...
Leave a comment:
-
Best spec. Would love one of these, but I'm also looking at E34 tourings more and more as well thanks to Varg and some other internet builds.
Carsandbids prices are high vs historical values, but...
Leave a comment:
No activity results to display
Show More
Leave a comment: