I've got my M50 almost fully put back together after stroking it and just got a new crank bolt. When installing and torquing it, is there a specific time I need to torque it or can I just go ahead and torque it with the engine on the stand, no flywheel, clutch, etc.? Also, to prevent the crank from spinning I assume I just need a friend and crankshaft pulley holder?
This is for sure a dumb question but I am a total freshman at this and don't want to mess anything up
This is for sure a dumb question but I am a total freshman at this and don't want to mess anything up
Comment