The comprehensive DOHC engine swap thread.

[Van Westervelt]

That smaller bracket holds the crank case vent tubes from the front corner of the valve cover.

[Matt-B]

the smaller bracket is designed for holding... Im not sure, but it goes between intake bracket and the small slot goes on the bottom fin of intake


One you see the 2nd pic, you can see it fits nice an snug in there






Other bracket, kinda the same deal, holds a heater hose i guess, but Mine wont reach
the end of the bracket shaped like this UU holds the fuels lines and need to be turned to make them run horizontal ish..

Hope that helps Josh, its cold outside

[Van Westervelt]

both go under the intake. the upper one is on the back and holds the fuel lines, the other is actually bolted to the dipstick tube I believe.

You can see the fuel lines and bracket in this pic of my original s50

[Matt-B]

grabbing pics now...

[Jand3rson]

Hay guise... I've got these 2 brackets that I'm trying to get installed on my M50, and I cannot figure out where they go. They look like they're both for hoses, but I can't figure out how they mount. Someone mind filling me in, or snapping a pic?

[drumad]

Sweet. I appreciate it.

[Matt-B]

ill get pics soon
my new parts are on the way
got it figured out....

[drumad]

want to look at your vacuum routing and etc and starter wires etc thanks buddy, call you about 10 or so AM

Hopefully you and the other guy would do this for me, but can I get pictures? I took pictures of my routing before I took it all apart but I'd like to see a completed swap set up.

(Yes, I know alot of shit can be in the way, but who knows.)

[Matt-B]

want to look at your vacuum routing and etc and starter wires etc thanks buddy, call you about 10 or so AM

[Wishno87]

Yea, I just need that fitting that goes from a small hose to big hose.
Thanks man, can I pick your brain tomorrow? Or come down and make some notes?

Ya sure. I think Im going to have the day off.

[Matt-B]

Yea, I just need that fitting that goes from a small hose to big hose.
Thanks man, can I pick your brain tomorrow? Or come down and make some notes?

[Wishno87]

Josh, what goes in 2nd hole of intake boot?

I know 1 hole is for the ICV to boot hose, and the other hole is for Valve cover to boot?

Yup other goes to the VC though that little pipe attached to the dip stick tube I think and then to the VC.

[Matt-B]

Josh, what goes in 2nd hole of intake boot?

I know 1 hole is for the ICV to boot hose, and the other hole is for Valve cover to boot?

[Wishno87]

I would install it. It is there to put even pressure on the FW no?

[Matt-B]

yea same question here...