New set has arrived! Front shaft uppgrade *Finland-Fix*

[nomansland92]

I'm in on this, I want a second one for future use ;)

Sent from my SAMSUNG-SM-G891A using Tapatalk

[rzerob]

I want one. Let me know when, where and how to pay.

[jute91]

I took my spare transfer case apart to get the sprocket for the machinist.
So I will be producing a new set of these extension by the local machinist. He have done severals machining for me so I can believe these in his hands. Of course I will be doing final inspection on them before sending any :)

[boogle2]

When they welded it up for me they said that the shaft only had a couple thou runout, so hopefully it will be ok with no vibrations!


Sent from my iPhone using Tapatalk

[jute91]

Looks good. I prefer you should all check your drive shafts are straight, before installing. noticed that mine had little vibration at 60mph, and now when its out, I noticed its not prefectly straight. the pipe has throw of couple millimeters in the middle of it. I dont believe the installing the new head on it reguires balancing since it's perfectly symmetrical, but if it's not pressed straight or welded well, it might bend the pipe little

[boogle2]

[/url]
[/url]

Got mine welded up today. Hopefully I did it right haha. Overall length is now 658mm.

[Wille30]

I have mine installed on a spare drive shaft ready to install. Has anyone installed one yet? I know you have to lower the TC, but that's it. I haven't dropped the TC before and am not really sure what is involved, but I am slightly nervous as it is my DD.

[stonea]

My dad would take one

[litu]

Just wonder how much this would cost, if some machine shop would make them??

[e30fix]

if you ever decide to make any more of these i will be in for one. im currently pulling the drivetrain from a manual ix to swap into my auto ix. hopefully youll be able to make some eventually i will definitely buy one.

[nando]

ok, don't want to rip anyone off - just what it originally cost is fine. send a PM. :)

[stonea]

I'll definitely take it off your hands. I'm still kicking myself for not picking one up earlier.

[nando]

I still have two of these. I could be convinced to part with one..

current plans are to just stick with the 4.10s. I might need them with my planned redline. :p

[monkey_boy]

sub'd for when these start getting made again (fingers crossed).

[Northern]

If everyone else offering cash falls through, I'll take it.

I have a set of 3.64 gearsets (Front from car's original diff, rear from haoming) but I'm not putting them in for at least another year, so I still need my 3.91's