New set has arrived! Front shaft uppgrade *Finland-Fix*

[jute91]

Good news, fellows!

shafts are ready for sale!

im going to sell them via paypal.. i will link picture later, when i get home.

price is 150 euros each which is near 190 dollars.. plus shipping of course..

Welding instructions


Welding Rod
OK 48.00 Non-mixture rod soft
OK 75.75
Conarc 48 Non-mixture rod soft
Conarc 80



MIG/MAG
OK Autrod 12.51 M21/M20 tai CO2 Non-mixture wire (Soft)
OK Aristorod 13.12 M21/M20 tai CO2
OK Aristorod 13.29 M21/M20 tai CO2
OK Tubrod 14.03 M21 Cored wire
LNM 26 M21/M20 tai CO2 Non-mixture wire (Soft
LNM 19 M21/M20 tai CO2
LNM MoNiVa M21/M20 tai CO2
Outershield 690-H M21 Cored wire

[325ixa]

like i said, near me. and we dont have driveshaft specialized shop. sorry if i made confusion.

[nomansland92]

Any driveshaft shop can balance it rather cheaply actually and I'm sure they could weld it to, but i don't see how welding it would be difficult.

[nando]

surely a driveshaft shop can do it?

somebody did it on my original lengthened shaft, I don't have any vibration issues.

[325ixa]

that is going to be big problem. welding shaft requires lots of skill. i dont know any welder near me who could do that. chance of vibrations is quite high.

[jute91]

and its you who desides what is your total driveshaft lenght.. you'll have to cut old shaft head off and weld a new one..

[jute91]

well with this shaft you have only 10mm left to hit the bottom..
splines in gearing are 60mm long and this has about 51mm long..

[nando]

I still wish the splines covered the entire end, so those of us with spacers/thicker flex discs could use one.

[monticello]

okay, so i got the steel yesterday. Finally got time to work with it.
So i made drawing this morning for the grease nipple.

Are you trying to lube the splines?

[jute91]

That long hole gives me headache :S broke 3 drill on 7 shafts... going to make 15 pieces at first.. 7 first are at this part of procedure..

[jute91]

sorry for this taking so long... i just had 2 weeks vacation of the school...
i got only wednesdays and thursdays time to make these things and i got only 4 hours for each... after all.. its only my school... not my job...
but however, yesterday i did 14 shafts to half way... need to drill lubrication channel and then make the splines... my school mate will do the splines for me. im now wondering do i need to give heat threatment to splines or not..
need to find out that..

[Bmjpv]

front d/shaft

Sound good, please count me in for one. Joe

[jute91]

well is it good 150 euros which is now about 190 dollars? heat treateted, ready to weld..

Heat treated Imacro M is able to weld, when T4140 isnt... im making new shaft model with that grease nipple so you can see it. Imacro m -steel should be arriving this week.

[Northern]

Let me know when you know a final price

[jute91]

well first i said price is 100 per each, but making of the splines lasts so long that i think it would be nice to get 150e each. And now it will gonna have grease nipple.. but i dont know how much shipping are.. need to find out it later..