3 eyed e30s

[russiane30]

Post some pics up of your velocity stack setups!

[korea619]

[nando]

it works too - 60% reduction in intake temps at low speed (20-35mph) and about 25% at high speed (50-100mph). It doesn't increase intake pressure though.

[87e30]

Not to totally distract... but why does everyone say that these are stupid? I like it, keep 'em coming.

[Van Westervelt]

[nando]

Not to totally distract... but why does everyone say that these are stupid? I like it, keep 'em coming.

not much point on a street car

they also seem to work better on cars with smoked front ends. you can barely tell that I'm missing a high beam, but on a car with clear lights it would stand out quite a bit.

plus a lot of general BS about what it does. It's very functional at reducing intake temps. Not great at producing any pressure.

[Disaster Inc]

not much point on a street car

and would make it impossible to pass the yearly rmv inspection here...

[erik325i]

[mcr_driver]

is that an oem csl intake manifold? if soo i think i need to start fapping...

[SA E30]

Doesn't look oem CSL isn't 2 piece and doesn't say BMW M Power on it.


Still is totally worth fapping over!

[wolfgangstbd]

anyone ever think of using a intake velocity stack? there O.D. is 6" on average tho. they are legit aluminum in like any color. i think it could make a good fit

[fiftytakedowns]

Can someone Post on how they did it with their US ellipisoids , or how they attached the Stack to the Bracket, ETC.
Where to get the stack, how to adapt the US ellip bracket.

[fiftytakedowns]

This was with my sealed beams

[fiftytakedowns]

\
it works too - 60% reduction in intake temps at low speed (20-35mph) and about 25% at high speed (50-100mph). It doesn't increase intake pressure though.

If you were to do a Hose Directly to the headlight (bracket) from the airbox
I'm pretty sure it would do something. I wonder if you could do a straight shot, or turn the airbox on it's side so the air goes through large hose directly through the filter into the afm, almost like the air is hitting a wall (filter), instead of going to the bottom of the airbox, up through the filter, and then up again into the Afm. I hope i'm making sense, but I seems like it would work to create a minimum amount of pressure.

[Drew325is]

Korea619, details of the stack you've used there?