What 4x100 wheels will fit e30s?

[rwh11385]

the wheels are free so i figure why not give it a try

good answer. yeah, give them a try with a moderate ride height and nonwide rubber.

all else fails, sell them to a e21 owner

[2002maniac]

I'm 7.5" wide ET20 and no rubbing or fender touching, and my car is lowered about 2.5" in the front! 205 tires though. If you ran 16x8" with 225's I think it would fit with a 25-27mm offset.

Where did you get your 16x7.5 rotas? I cant find them anywhere. Everyone has 16x7 only

[Digitalwave]

I was talking about my throwing stars.

[2002maniac]

oops. I didnt realize this thread was so old.

[shiraz]

I have these on my car...I didn't want spacers, they fit without. TSW Kyalami

[E30_pilot]

Personally i dont like them. The lip isnt like that on the pic advertise.
Here's how the look for our cars...pics are not of my car ;)

[shiraz]

Personally i dont like them. The lip isnt like that on the pic advertise.
Here's how the look for our cars...pics are not of my car ;)

Mine are bigger than that and have the Hyper Black finish rather than whatever that is. The lip on mine is the same as in the picture I showed, which is the hyper black finish as well. They look quite a bit different and really alot better...if I can find my camera I will get pictures of them on my car.

There is also another wheel made by TSW that fits these cars I believe...the Catalunya I think? This one...again in a hyper black finish.

[duuuurtymyk]

what about 15x8 zero offset? have you seen the sportmax's...super deep 3inch lip?

[s52e368]

so im looking at some wheels
15x7
+38mm

ill need a 5-10 mm spacer correct ?
also is it safer to go with a stud kit or just longer bolts ?

[rwh11385]

38 is wayyyy too high. no one makes 5 or 10mm hubcentric spacers, but the good thing is that a 15mm H&R puts you are ET23 which is good for a 7inch rim.

studs make the job a lot easier. try lining up a wheels and spacer then getting a bolt in. fuuunnnn. you'd need long ones since most medium ones can only fit a 12mm spacer.

too bad a set of 15mm spacers will cost you about $180-200

[Digitalwave]

so im looking at some wheels
15x7
+38mm

ill need a 5-10 mm spacer correct ?
also is it safer to go with a stud kit or just longer bolts ?

15 or 20mm would be preferable. You could run 10mm though, it'd just sit inside the fenders a lot.

Studs are nice because its almost impossible to line the wheel + the spacer up to the bolt holes and stick the bolts through.

[rwh11385]

VWVortex has nice selection of 4x100, 57.1 centerbore wheels. some offsets are high, but some are okay, just with narrow wheels.

i was frustrated trying to find euro weaves, so i looked otherwhere for other wheels

[s52e368]

well i found some vw k1's

so the centerbore would be the same. but the offset is 38

[rwh11385]

http://forums.vwvortex.com/zeroforum?id=800

and besides the "e-ballers" on clean slammed show cars and RS's, they are cheaper/poorer than us so you can get some sick deals.

http://forums.vwvortex.com/zerothread?id=2658344

15"x6.5" ET33 4x100 Factory corrado G60 wheels complete with mint center caps. Minimum curbrash, and a couple bends on the inside lip on 1 wheel but all hold air and drive fine. Located in toronto/brampton/hamilton area.
Asking $450 CDN for the wheels without tires. [$400 USD]



15x6.5 et33 is okay to run with 205s on E30s, same width as basketweaves, just you have a bigger wheels for better looks (and more $ tires, but much much easier to get good 205). I'd rock out those with undersized 205-50-15 cheap sticky tires and they would look bigger and a little better acceleration

http://forums.vwvortex.com/zerothread?id=2672756 - a set of 6 corrado rz wheels. if we buy both, we can both have a set of 5 direct fit BBS RZ's

there's a lot of others there too. i'm passing on the 6" ones, hoping for 7inchers, but definitely would rock 6.5" if I was wanting to run more 205-50-15

[s52e368]

http://forums.vwvortex.com/zeroforum?id=800
there's a lot of others there too. i'm passing on the 6" ones, hoping for 7inchers, but definitely would rock 6.5" if I was wanting to run more 205-50-15

without spacers ?