hey everyone need some help I bent valves in my m20b25 due to a bad timing belt ive been going crazy looking for a motor with low miles and I just found one in months of hunting for one. only thing is It came out of a 5spd and my car is a automatic would the motor bolt up to my automatic transmission ?
Announcement
Collapse
No announcement yet.
will standard m20 motor be compatible with auto tranmission
Collapse
X
-
Originally posted by bostonvert View PostCan anyone clarify what this bearing exactly is?
It sits in the end of the crankshaft and supports the input shaft of the manual transmission. It is not used with an automatic transmission.
It's part #1 in the attached. (7/86 eta car example shown)
101
The E30 collection:
1987 325es M52 - Schwarz / Taurus Red Sport (son #2's)
1987 325is - Delphin / Black Sport (son #3's)
1987 325i Convertible - Triple Black
1989 325iX Coupe - Diamondschwarz / Black Comfort
1990 325iX Coupe - Sterling Silver / Grey Sport
1981 Fiat 124 Spider 2000 - Green / Tan
1998 Volvo V70 GLT - White / Tan
1998 Volvo S70 T5 manual - White / Taupe
2001 Ford Windstar - Silver / Grey (parts hauler)
2006 Lexus GX470 - White / Tan (tow rig)
Comment
-
Originally posted by 101 View PostPilot bearing?
It sits in the end of the crankshaft and supports the input shaft of the manual transmission. It is not used with an automatic transmission.
It's part #1 in the attached. (7/86 eta car example shown)
http://www.realoem.com/bmw/enUS/show...diagId=11_1937Originally posted by TobyB View Post
this.
tInstagram : makeitsnap
1985 e28 520i
Comment
-
In the process of an engine swap (my car is a automatic) but I bumped in to a small issue :
The donor engine is a manual, the problem is that the torque converter does not fit the manual engine. There is an extra bearing for the manual transmission. Does this mean I have to change out the crankshaft? It doens't look like it is possible to remove the bearing.
This is the automatic engine
And this is the manual engine
Instagram : makeitsnap
1985 e28 520i
Comment
-
You remove the bearing and reinstall your auto trans torque plate. If you dont have a bearing puller stuff the hole full of greaseand use a drift close to the size of the hole.Seat Shocks....I have passed the baton to John Christy from Ninestitch. Email John or Garrett at ninestitch1@gmail.com
https://www.r3vlimited.com/board/sho...86#post4944786
Alice the Time Capsule
http://www.r3vlimited.com/board/showthread.php?t=360504
87 Zinno Cabrio barn find 98k and still smells like a barn. Build thread http://www.r3vlimited.com/board/show...20#post3455220
Comment
Comment