M20 - R3VLimited Forums

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

	Topics		Statistics	Last Post
	Sticky: Stroking/boring M20B25/B27: Sectioned blocks show critical dimensions. PICS! by LJ851 Started by LJ851, 04-14-2013, 11:13 AM		98 responses 39,343 views 0 likes	Last Post by digger 08-28-2022, 04:24 PM
	Sticky: 1.3 Motronic Up-Grade & 2.7i How To by kenika65 Started by kenika65, 12-17-2007, 10:27 PM		499 responses 193,879 views 0 likes	Last Post by herschelcv 08-21-2022, 01:13 PM
	Car does not idle, but will rev and drive (but misses) by RP808 Started by RP808, 06-02-2014, 11:36 PM		4 responses 382 views 0 likes	Last Post by AndrewBird 06-03-2014, 04:26 PM
	large oil leak by Daeldalus Started by Daeldalus, 06-03-2014, 02:08 PM		1 response 321 views 0 likes	Last Post by jlevie 06-03-2014, 02:23 PM
	engine dies upon acceleration 0 suggestions? by vvurdsmyth Started by vvurdsmyth, 06-02-2014, 02:44 PM		5 responses 482 views 0 likes	Last Post by jd_e30 06-03-2014, 08:20 AM
	Stripped Valve Nuts by anokES Started by anokES, 06-01-2014, 09:38 PM		1 response 342 views 0 likes	Last Post by jlevie 06-02-2014, 06:35 AM
	1987 325is hard start when hot/warm by flipwils11 Started by flipwils11, 05-31-2014, 02:35 PM		4 responses 2,490 views 0 likes	Last Post by TobyB 06-01-2014, 09:19 PM
	Bad evap system= rough warm-up? by NoM54me Started by NoM54me, 06-01-2014, 07:46 PM		0 responses 297 views 0 likes	Last Post by NoM54me 06-01-2014, 07:46 PM
	Bottom end clean up by cgk_iii Started by cgk_iii, 05-31-2014, 11:33 AM		8 responses 741 views 0 likes	Last Post by cgk_iii 06-01-2014, 07:17 PM
	Oil leak from Oil cooler lines by 89EtherTeeMan Started by 89EtherTeeMan, 06-01-2014, 09:49 AM		5 responses 1,007 views 0 likes	Last Post by jlevie 06-01-2014, 01:14 PM
	1988 320i (M20B20) Troubleshooting Help by Shock(/\)ave Started by Shock(/\)ave, 06-01-2014, 11:01 AM		1 response 615 views 0 likes	Last Post by mikeedler 06-01-2014, 01:06 PM
	will a bobbed crank for 2.8l stroker balance out? by kickinindian Started by kickinindian, 05-29-2014, 04:56 PM		17 responses 866 views 0 likes	Last Post by redlightpete 05-30-2014, 04:23 PM

Previous 1 267 317 357 364 365 366 367 368 369 370 377 417 467 867 1106 template Next

No topics found.

Mark This Channel Read

Working...

X