Hello?
Announcement
Collapse
No announcement yet.
Cold start, Unable to drive.
Collapse
X
-
Originally posted by fiftytakedowns View PostCrank position Sensor 512 Ohmssigpic
...
The Keystone Killers: for the Commonwealth!
Member #18 of M42Club.com
1991 318is Diamantschwarz Black
1992 850i Calypso Red
Comment
-
Originally posted by X_WizarD_X View PostThat seems low for the CPS, but don't know if that is the problem...My car wouldn't even start with the reading that low...[/url]
Team USA Wrestling 67KG
Team USA Wrestling Strength And Conditioning Coach
Comment
-
Im going to re-test my sensors, will report back. I dont understand how this can be happening there has got to be a bad signal somewhere.
LEts assume I just encountered this problem, What series of tests would you conduct to try and pinpoint the problem, being fuel, or spark related?[/url]
Team USA Wrestling 67KG
Team USA Wrestling Strength And Conditioning Coach
Comment
-
sounds alot like the cps, did you see my thread about the problem I was having? about sludge and dirt buildup on the cps? clean it with some carb cleaner.Your signature picture has been removed since it contained the Photobucket "upgrade your account" image.
Originally posted by Wh33lhopVANOS: sometimes you just need to go full retard.
Comment
-
Just thinking out loud here. From my experience with MSQ, if you don't have enough cold start enrichment the engine will run like crap for the first couple of minutes. Now if you had a failed coolant temp sensor on the M42 so that it read HOT all the time, the engine would be running way lean on cold start. Sorry if this has already been addressed in the thread.
Comment
-
Originally posted by Killacortes View Posti didnt read everything on this thread, but the same thing happened on my car changed the plugs and found one bad coil. picked up a free used coil and booom runs like a champ
Buttchug, I swapped in junkyard AFMs, and had no luck. I think I even bought an AFM off of a member with no luck.
justin,
This morning I got a cup of boiling water, and stuck my spare CLT sensor in it, with it connected to the wiring harness. and I had no luck in causing or finding any problems. I have a new CLT and a spare one off of a running engine. I have swapped em in and out with no luck.
I did unplug the camshaft position sensor, and reset the computer. I was getting the same symptoms, however, the backfiring was much more rhytmic
pop pop pop pop pop popop (not revving higher than 1500 RPMS, but holding it.)
as opposed to camshaft sensor in.
POP boggggggggg pop POp bogggggssss down back to idle. or dies.
yo, Thanks everyone for your help. whoever has the winning discovery I have some spare VDO gauges I can distribute. :D
VDO gauge winner chooses one --> http://dl.dropbox.com/u/11819570/VDO%20Gauges.JPG[/url]
Team USA Wrestling 67KG
Team USA Wrestling Strength And Conditioning Coach
Comment
-
also, are you sure that the plugs are hooked up to the right plugs? That causes backfiring popping and a shitty driving experience.:rofl:Your signature picture has been removed since it contained the Photobucket "upgrade your account" image.
Originally posted by Wh33lhopVANOS: sometimes you just need to go full retard.
Comment
Comment