MMP M62B44 Build Project "Jack-N-Coke"

[MonkeyMadness]

Any progress on the harness? Keen to see this running and skidding :P

NO sadly I'm Elc. stupid... and my attempt to build my own failed horribly..ugh
But i found one and its on hold for me in San Diego I just have to get my happy ass down there to pick it up...

then my plan next will be to get it running FIRST, with the stock harness!
Then... I'll tuck that harness...

[econti]

Any progress on the harness? Keen to see this running and skidding :P

[MonkeyMadness]

So I glued it back in place and we"ll see how well it turns out tomorrow


Doesn't look too bad...

[MonkeyMadness]

So I pulled it all and got the car all cleaned up..







Now sitting in my empty car looking at the head liner and then I remembered what Levent (GPS)did with Black Beauty, Damn I'm dying my head liner black too...



Oh and yes I'm already working on fixing my damn sunroof...ugh

[MonkeyMadness]

Ok so sitting in my car making vroom vroom sounds daydreaming of a finished project when I look down and realize just how ugly and bad looking the carpet is.

So I'm pulling that shit out to dye it. Will post before and after pic's stay tuned or just go get a drink...





Yuck!


And I pulled the deck cover to do too...

[MonkeyMadness]

Sourcing a new harness now...

Might be rolling south to San Diego this weekend...

[Denny]

sub'd

[MonkeyMadness]

Ok kids I'm back in California, let see if we can get this damn thing finished...!

[The Dark Side of Will]

Perseverance...

[MonkeyMadness]

Holyshit. Wired in my starter today and my gawd damn windows and sunroof are working now!
Yea everything works now....except the motor harness

Sent from my SPH-L900 using Tapatalk

[TheTacoMan]

Ergen motorsports may also have something, I see their Facebook posts about wiring harnesses all the time.

[The Dark Side of Will]

I built a bitchin harness and it was tucked and clean and didn't work. :razz:

Lesson: Don't tuck it until it works... ;)

If you have a harness that plugs into everything, just go through with your volt meter set for "continuity" and figure out what's not connected where it needs to be. Tedious, but less work than building a new harness.

[JGood]

M50 and m60 x20 connectors are identical. I have a write-up on where to find the schematics and how to read them. It's a sticky thread in the 24v swap forum. This is one of those things I'd highly recommend learning and doing. It's so easy, and will make troubleshooting future problems much easier.

[TheTacoMan]

This guy may be able to help you out.
http://www.r3vlimited.com/board/showthread.php?t=275468

[MonkeyMadness]

I need a plug n play harness for a v8 swap. obd1 and willing to pay what is needed..ugh